Knob Diode is an auxiliary electrical part: part of the set wiring, protection or indication.
Before replacing, measure continuity and voltage under load. A terminal that shows continuity at no load can drop completely once current flows, and that is the case that wastes the most time.
Specifications and compatibility
- Model
- 600A -
- Amperage
- 150 A
- Dimensions
- 5 x 5 x 5 cm
- Weight
- 0.20 kg
How to verify before ordering
- Match voltage, current and conductor cross-section to what the circuit demands.
- Check the connection type (screw, spring, crimp) and terminal gauge.
- Confirm the IP rating if the part sits in an exposed area of the panel.
- The reference shown on this listing is 600A -; cross-check it against the one stamped on the removed part.
Frequently asked questions
Why does a terminal get hot?
Contact resistance: too little clamping area or a bad crimp. The heat oxidises the joint and worsens it until the circuit opens.
Can I fit a relay with a higher amp rating?
You can, and it is often good practice, provided coil voltage and contact arrangement match. Never fit one with a lower rating.
Related parts
- Rectifier bridge - Press-Fit Diode
- Contactor - CJ20
- Lighting - public lighting street lights (flat type)
- Transformer type box - series BCP-13.8kV
- Lighting - AD16-22D/S
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Model | 40A Positive, 150A Positive, 400A Positive, 40A Negative, 150A Negative, 400A Negative, 70A Positive, 100A Positive, 500A Positive, 100A Negative, 70A Negative, 500A Negative, 200A Positive, 600A Positive, 200A Negative, 600A Negative, 25A Positive, 300A Positive, 25A Negative, 300A Negative |
| Amperage (A) | 25 A, 40 A, 70 A, 100 A, 150 A, 200 A, 300 A, 400 A, 500 A, 600 A |
