Skip to Content

AVR - Automatic Voltage Regulator SR7

https://www.bochipower.cc/web/image/product.template/953/image_1920?unique=9b4d277
(0 review)

The AVR SR7 is a voltage regulator designed to provide stable control in generators. Its sensing input is versatile, allowing “Y” or single-phase connections from 220 to 480 V CA at 50/60 Hz through its 1, 2, 3, 4, 5, 6 terminals. The power input is 50 to 280 V CA (terminals 1, 2) at 50/60 Hz. As for the output, it provides a maximum voltage of 90 V CC with 220 V CA harmonic wave input, and a continuous current of 6A, with a maximum capacity of 8A for 10 seconds.

$ 90.47 90.47 USD Tax Excluded

90.47 Bs Tax Excluded

  • Model
  • Generator Parts
  • Applicable To
  • Weight
  • Dimensions

This combination does not exist.

Terms and Conditions
30-day money-back guarantee
Shipping: 2-3 Business Days

AVR - SR7 belongs to the generator excitation circuit and holds the output voltage within about ±1 % when the load steps up or down.

AVR wear is thermal. It works inside the generator compartment with no ventilation of its own, so it is usually the first module to age on a high-hour set. Keeping one on the shelf avoids a multi-day stop for a low-cost part.

Specifications and compatibility

Applicable to
MECC ALTE
Dimensions
17 x 6,5 x 13 cm
Weight
2.00 kg

How to verify before ordering

  • Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
  • Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
  • Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.

Frequently asked questions

How do I know the fault is the AVR and not the generator?

Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.

Can the voltage be trimmed after installation?

Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.

Related parts

See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.

Specifications

Characteristics
Model SR7
Applicable To MECC ALTE
Weight 2,00 kg
Dimensions 17 x 6,5 x 13 cm
Spare Parts
Generator Parts AVR