AVR - Automatic Voltage Regulator M40FA610A
The Marelli Motori M40FA610A is a “W1” type voltage regulator for Marelli Motori series M8B and MJB (160-500) synchronous generators from 10 to 2000 kVA. Fully isolated for high reliability in severe environmental conditions (humidity, dust, salt, vibration), it is suitable for single-phase and three-phase operation. It offers a voltage source and sensing of 170-277 V (50/60 Hz), with a continuous field current of 8 A (15 A forced for 1 minute) and a maximum field voltage of 100 V. It stands out for its regulation accuracy of ±1%, thermal drift of ±0.5% and a response time of 1 cycle, operating between -20°C and +60°C.
AVR - M40FA610A belongs to the generator excitation circuit and holds the output voltage within about ±1 % when the load steps up or down.
AVR wear is thermal. It works inside the generator compartment with no ventilation of its own, so it is usually the first module to age on a high-hour set. Keeping one on the shelf avoids a multi-day stop for a low-cost part.
Specifications and compatibility
- Brand
- OEM
- Model
- M40FA610A
- Applicable to
- MARELLI MOTORI
- Dimensions
- 22 x 6,5 x 13 cm
- Weight
- 2.00 kg
- Country of origin
- China
How to verify before ordering
- Check that the reference printed on the AVR label (for example AS440, MX341, R120) matches exactly; variants differ in sensing range and excitation level.
- Confirm the excitation input voltage and the generator type it serves. They are not interchangeable across generator makes or speed ranges.
- Inspect wiring and brushes before replacing the module: a loose connection produces exactly the same symptoms as a burnt AVR.
- The reference shown on this listing is M40FA610A; cross-check it against the one stamped on the removed part.
- Declared origin: China. Check this if your purchase requires a specific origin.
Frequently asked questions
How do I know the fault is the AVR and not the generator?
Measure output voltage at steady load. If it is low and does not respond to the excitation trim, while windings and rotating diodes are healthy, the AVR is the suspect. A cross-test with a spare AVR confirms it in minutes.
Can the voltage be trimmed after installation?
Yes. Most of these regulators have a voltage and a stability trim pot. Set them at no load to the site nominal voltage, then verify under load before signing off.
Related parts
- AVR - Automatic Voltage Regulator M25FA600A
- AVR - Automatic Voltage Regulator M40FA640A
- AVR - Automatic Voltage Regulator VR6 365-2076
- AVR - Automatic Voltage Regulator GAVR-12A
- AVR - Automatic Voltage Regulator DVR2000E
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Characteristics | |
|---|---|
| Brand | OEM |
| Country of Origin | China |
| Model | M40FA610A |
| Applicable To | MARELLI MOTORI |
| Weight | 2,00 kg |
| Dimensions | 22 x 6,5 x 13 cm |
| Spare Parts | |
|---|---|
| Generator Parts | AVR |
